How I find the “Sweet Spot” 4 Parts Wicked Edge Precision Knife Sharpener
How I find the “Sweet Spot” 4 Parts Wicked Edge Precision Knife Sharpener

How I find the “Sweet Spot” 4 Parts Wicked Edge Precision Knife Sharpener

To make the eyes pop in two simple steps, start with your lowlight. This is a basic strategy to slim down the nose just a bit . For the nose, use the same lowlight shade you used for cheeks. Start at inner corner of brow and apply down either side of the nose. For honing, clamp the blade back in where you drew your box. It has very few flaws for such a large knife and the bevel is ground pretty consistent. Derek sent me one of the knives with the request that I find the sweet spot to help him to learn how to do it by showing him how I do it.

What Exactly Are Cuticle Nippers?

If your scissors stick in the open or close position as you make your cuts, they might have rust or grime stuck in between the blades. Apply WD-40 in between the blades to make them cut smoother.

Since you normally use the front 3/4 of your scissors, you don’t need to test the back 1/4. If you are going to do surgery with your scissors, make sure you are holding them in the surgeon’s form, or how you would hold them during surgery.

Staplers

Read more about Jaw sculp here.

I would use a carbide reamer to cut through the anodize and a HSS reamer to finish, if you have enough material. One problem that hasn’t been noted is that once the cutting edge is dull, the aluminum oxide will wear on the OD, making it tapered. Maybe one flute will do all the cutting, but it is so easy to regrind that it would not matter. Once the anodizing is gone, your finish reamer should last for many jobs, and that is the one to send out to a pro. I have sharpened a lot of adjustable blade reamers with a regular flat bench stone, but they are adjustable so I do not worry about size. Hold the reamer in the vise, stone the relief face until the wear land is gone. In conclusion, maintaining sharp cuticle nippers is crucial for achieving professional-looking manicures at home.

Hammer Drill or Rotary Hammer?

Now flip to the other blade and line up to your mark again. Since the blade is curved down and around the machine, sharpen on the outside edge of the wheel because it will be really easy for the inside edge to cut into the blade. Finish by deburring with the spread to close, pinch to open method. Next, with the knife positioned and clamped, I like to inspect and photograph, , the knife’s bevel and edge grind to see what I’m dealing with.

Disassemble the tool if you need to work on this section. Check the jaw’s edge for rounded areas; These areas must be honed into a flat, not sharp, edge. Turn the blade over and lightly run your whetstone flat on the other side of the blade to remove any burrs. Retrieve the tool afterward and use a wire brush to remove the loosened rust. Refer to the tool’s manual for disassembly, then loosen the bolt and separate the two main parts. Remove any rust from the pivot areas with sandpaper, and then reassemble the tool afterward.

Cut the latex sheet 5 to 10 times for an accurate test. Continue making small cuts to test your scissors for a couple of minutes. Take note of how your scissors hold up after multiple cuts to see if they are really sharp. ⚠️When using either of the first two techniques mentioned below, it’s best to unscrew the scissors, and sharpen each blade individually. If the blades are riveted together, keep one blade out safely out of the way when sharpening. Use a flat steel file to sharpen each tip of each blade.